What Is The Best Way To Transport Villagers In Minecraft. The chore of transporting villages and mobs over long distances is crucial yet time-consuming. Players could only start new villages or set up baited mob traps if they did so. Thankfully, there are some inventive solutions to make the journeys go more quickly and easily. We’ll show you the top 5 best ways to move villagers and mobs in Minecraft in this article.
Table of Contents
1. Job blocks/beds
A single unemployed villager can moved using either a job site block. Simply pick up that block and set it nearby to attract the villager’s attention. After that, keep breaking and re-placing the block to attract the villager to where you want it to go.
Beds can used to shift the villager about at night. This is, however, quite dangerous, as mobs such as zombies can spawn and completely destroy your day. Furthermore, if you want to transfer an entire village at once, you can destroy all of the beds, job site blocks, and the village bell, then lure with the same method.
2. Use a lead
When a player uses a lead on a mob, the lead attached to the mob and can moved by the player. Leads can hold multiple mobs at once, but each mob requires its own lead. If a mob can ordinarily leashed, a lead can used to remove them from a boat without breaking it.
3. Use a boat
This is most likely the simplest method of transporting a single villager over long distances. Simply place one in a boat and drive the boat, which may rowed slowly over land. A piston or an upward bubble column can used to propel the boat upward.
It is also possible to pull a boat up using a lead in Bedrock Edition.
Also Read: How To Make Smooth Stone Slab In Minecraft Pocket Edition
4. Water path
To employ this approach, players must construct a tunnel or a walled passageway that has no exits. After that, drive residents down the patch a few blocks at a time with two buckets of water. With your bucket, retrieve the water block furthest back and repeat the process.
A soul sand bubble column can used to move villagers or mobs higher. If the tunnel is flat, a sign above an ice block or an open fence gate can used to prevent the water source block from flowing backward, resulting in a cheap “railway.”
5. Minecart
This is the most involved way, as it entails constructing a minecart track from one point to another. Players can then load a villager or mob into the cart and drive it to its destination.
6. Nether portal
If no portals have built in the Nether, players can use Nether Portals to travel. Simply establish a portal at the Overworld location, enter it, and exit it immediately. After that, construct a second portal fewer than 128 blocks away from the first and shove villagers through it.
Pull the villager back out, wait 30 seconds, and then re-insert them. The villager should next proceed to the second portal.
